IMAGE® Herbicide Brush & Vine Killer

IMAGE® Brush & Vine Killer is a postemergent, non-selective herbicide for use on unwanted brush and vines. Brush and vines are killed completely with no regrowth from the roots. The treated area can be replanted in just one month.

Apply IMAGE Brush & Vine Killer anytime brush is actively growing

Covers up to 4,000 sq. ft.

Kills...


Judzu

Kudzu

[No text i field]
Poison Oak

Poison Oak

poison ivy

Poison Ivy

Blackberry

Blackberry

Horsetail

Horsetail Brush

IMAGE® Herbicide Brush & Vine Killer Application Instructions

IMAGE® Brush & Vine Killer anytime brush is actively growing: In spring, apply after leaves are fully open. In summer, apply when there is sufficient water. In the fall, apply before leaves begin to change color. Spray when the air is calm and there is no wind. Wet the brush completely with the spray. This product works through the leaves and bark - excess spray that runs off onto the soil will not improve control. After leaves have dropped off (4-6 weeks after spraying), cut down the brush and dispose of it. Once the brush is gone, the area may be replanted.

Ready-To-Spray Application

Applying IMAGE® Herbicide is easy and requires little cleanup.

This ready-to-spray bottle requires no mixing or measuring.

Apply at the rate of 1 quart of this product to cover up to 4,000 sq. ft.

Make sure knob control lever is in the OFF position. Shake well and attach to hose.

Turn water on a faucet, aim nozzle toward brush and turn control lever to ON to begin spraying. The product will automatically siphon and mix with water.

When finished turn control lever to OFF position. Turn faucet off. Discharge residual water pressure by turning control lever ON and OFF again.

Concentrate Application

Mix with water and spray using a pump sprayer or a hose-end sprayer.

Shake well before using.

Follow the mixing instructions below. Use the higher amounts when conditions are especially dry and on mature or hard to kill brush (such as ash, blackgum, chokeberry, elm, maple, oak, pine or winged elm), to prevent resprouting. 

Use this amount of Brush & Vine Killer in this amount of water to cover this area

½ - 1 cup (4 - 8 fl. oz.) - 1 gallon - 500 sq. ft.

1 - 2 cups (8 - 16 fl. oz.) - 2 gallons - 1000 sq. ft.

1½ - 3 cups (12 - 24 fl. oz.) - 3 gallons - 1500 sq. ft.

For stump treatment: Right after the tree or bush has been cut down, apply this product to the stump. Use the product straight from the bottle; do not add water. Use a paint brush or small sprayer to completely cover the freshly cut surface.

Ready-To-Use Application

The Ready-to-Use gallon product is the no-mix way to kill tough woody plants and brush.

Shake well before using.

Remove sprayer from bottle and remove from bag.

Slide the sprayer cap down the hose to the stop position. Remove child resistant cap from the bottle and discard cap. Place sprayer hose into bottle and screw sprayer cap on securely. Turn sprayer nozzle to selected pattern and spray.